A certain degree of customization is possible with this 16-hour advanced course.
Please contact EnviroSim to discuss the needs of your organization. The case studies and discussions may cover some of the following topics:
Review of Useful Features in BioWin
- The interface
- Customizing BioWin
- New elements
- Model options
- Mass balance / Kinetic information
- Numerical solver settings
- Ash content of biomass
pH Modeling
- Aerobic digestion of WAS
- Lime addition for pH control
- On/off aeration
BioWin Controller Module
- Aeration control
Methanol Addition
- Model considerations
- Accounting for methanol consumption
- System start-up
Aeration Systems
- Fine versus coarse bubble
- Gas phase modeling
Membrane Bioreactors
- Setup in BioWin
- Nutrient removal MBRs
Biofilm Modeling
- Model basis
- IFAS system
Anaerobic Digestion
- Glucose and gas production
- State variable input
- Combined primary and waste sludge
- Adjusting VSS destruction
- Primary sludge fermentation
Struvite Precipitation
- Struvite
- HDP
- HAP
- In-digester and post-digester formation
Chemical Phosphorus Precipitation
- Ferric / alum
Sidestream Treatment
- Digester return stream
- Two-step nitrification
- Two-step denitrification
- Anammox
SBR Systems
- SBR modules
- WERF wastewater characterization system
Oxidation Ditch Systems
- Ditch recirculation rate
- Surface aerators
- BNR in oxidation ditches
- SND – simultaneous nitrification denitrification
